Information:


Screws involved:
Philips

Size 2 hex


TABLE OF CONTENTS


Guide


Step 1: Undo screws on print-head cover


Step 2: Slide off print-head cover to access hotend


Remember the blower fans on the print-head cover are still connected, be careful.  


Step 3: Undo screws on hotend fan


Step 4: Disconnect old hotend fan cable from fan connector on print-head PCB board


Step 5: Reconnect new hotend fan cable to fan connector on print-head PCB board


Step 6: Redo screws on hotend fan


Step 7: Slide the print-head cover back in place aligned with the screw holes.


Step 8: Redo all the screws on the print-head cover. 



End of guide.